Installation Process

We arrive in the morning, confirm some details with you and begin work. The first part is to prepare the ground and to lay a 4' Bed of stone down.

The concrete is then installed, along with the base coat, and release powder. Rubber mats are then used to imprint the relevant pattern.

Once the pattern has been imprinted, the concrete is then allowed to set (this usually takes about 24-48Hrs), We then return, wash off the release powder and put in the expansion joints.

Once the above is all done you can now walk on the driveway, but its not ready for you to drive on yet. We return on a dry day and seal your driveway. Leaving you with a stunning looking drive ready to use.